Panasonic Switch-M12PWR Operation Manual page 205

Available commands are listed below.
S Change the target port of the counter value display.
Press "S." The command prompt changes to "Select Port number>." Enter the
port number you wish to display.
N Show the values of the next port.
Press "N." The screen displays the counter values of the next port. After you
reach Port 14, you cannot go back to Port 1 by pressing "N."
P Show the values of the previous port.
Press "P." The screen displays the counter values of the previous port. This
command is not available on the Port 1 screen.
r Change the counter values with those accumulated after resetting the counters.
Press "r." The counter values are immediately changed with those accumulated
after resetting the counters. The time display field on the upper right corner of
the screen changes to Elapsed Time Since System Reset.
f Set the counter refresh mode.
Press "f." The comment line displays "1 for start to refresh, 2 for set refresh
rate." Enter 1 to cancel refresh. The Refresh parameter displays "STOP," and
the display is not refreshed. Enter 2 to change the refresh interval. The
command prompt changes to "Input refresh time>." Enter the refresh interval.
The Refresh parameter is displayed accordingly.
Q Return to the previous menu.
205