Set Leave Mode Menu - Panasonic Switch-M12PWR Operation Manual

4.7.10.a. Set Leave Mode Menu
On the IGMP Snooping Configuration Menu, pressing "L" opens the Set
Leave Mode Menu as shown in Fig. 4-7-54. On this screen, you can set the
operation after receiving a Leave packet.
PN23129K/PN23129A Local Management System
IGMP Snooping Configuration -> Set Leave Mode Menu
Leave Delay Time : 5 sec
Port Mode
------ ------------
1 Normal
2 Normal
3 Normal
4 Normal
5 Normal
6 Normal
7 Normal
8 Normal
9 Normal
10 Normal
-------------------------------- <COMMAND> -----------------------------------
[N]ext Page
[S]et Leave Mode
Command>
Enter the character in square brackets to select option
Screen Description
Leave Delay Time
Port
Mode
Available commands are listed below.
N Show the next page.
Press "N." The screen displays the next page.
P Show the previous page.
Press "P." The screen displays the previous page.
S Set the operation after receiving a Leave packet.
Press "S." The command prompt changes to "Select port number to be changed>."
Enter the port number you wish to configure. Then, the command prompt
changes to "Set leave mode (N/I)>." Press "I" to send a Leave packet to the router
port immediately after receiving it. Press "N" to wait for the specified Leave Delay
Time before sending it to the router port.
T Set the waiting time after receiving a Leave packet.
Press "T." The command prompt changes to "Set leave delay time>." Set the time
to wait after receiving a Leave packet in seconds between 1 and 10. (Factory
default setting is 5 seconds.)
[P]revious Page
Set Leave Delay [T]ime
Fig. 4-7-54 Set Leave Mode Menu
Displays the waiting time after receiving a Leave packet.
Displays the port number.
Displays the operation after receiving a Leave packet.
184
[Q]uit to previous menu