Panasonic Switch-M12PWR Operation Manual page 37

Available commands are listed below.
I Set/edit the IP address.
Press "I." The command prompt changes to "Enter IP address>." Enter an IP
address for the Switching Hub.
M Set/edit the subnet mask.
Press "M." The command prompt changes to "Enter subnet mask>." Enter a subnet
mask for the Switching Hub.
G Set/edit the IP address of the router for the default gateway.
Press "G." The command prompt changes to "Enter new gateway IP address>."
Enter the IP address of the router, set as the default gateway.
A Set the IP address, subnet mask and default gateway in succession.
Press "A." The command prompt changes to "Enter IP address>." Enter the IP
address of the Switching Hub. Then, the command prompt changes to "Enter
subnet mask>." Enter the subnet mask. Then, the command prompt changes to
"Enter new gateway IP address>." Enter the IP address of a router, used as a
default gateway.
D Disable/enable the DHCP mode. If enabled, an IP address is automatically obtained
from the DHCP server.
E Enable the DHCP mode. (A DHCP server must be operating on the network.)
D Disable the DHCP mode.
R Renew an IP address from the DHCP server.
Press "R." The command prompt changes to "Renew DHCP (Y/N)." To renew, press
"Y." Otherwise, press "N."
Q Return to the previous menu.
Note: The above items must be set in order to use the SNMP control
function and to enable a remote connection by Telnet or via WEB.
Any IP addresses on the local network must be unique and no
duplication is allowed. If you are unsure, consult the network
administrator.
37