Table of Contents
Advertisement
Available commands are listed below.
E
Configure the IGMP Snooping Querier function.
If you press "E," the command prompt changes to "Enable or Disable querier
status (E/D)>." Press "E" to enable the function. Press "D" to disable it.
V
Set the version of IGMP queries to be sent.
If you press "V," the command prompt changes to "Enter IGMP version (1/2)>."
Press "1" to use Version 1. Press "2" to use Version 2.
I
Set the IGMP query sending interval.
Press "I." The command prompt changes to "Enter query interval >." Enter a
value between 1 and 18000 (seconds).
M Set the IGMP query response waiting time.
Press "M." The command prompt changes to "Enter max response time >."
Enter a value between 1 and 25 (seconds).
T
Set the time before determining that there is no longer another Querier.
Press "T." The command prompt changes to "Enter querier timeout >." Enter a
value between 60 and 600 (seconds).
C
Set the number of queries sent when an STP topology change is made.
Press "C." The command prompt changes to "Enter TCN query count >." Enter a
value between 1 and 10 (the number of times).
N
Set the interval of sending queries when an STP topology change is made.
Press "N." The command prompt changes to "Enter TCN query interval >." Enter
a value between 1 and 10 (seconds).
Q
Return to the previous menu.
189
Advertisement
Table of Contents
