Traffic Class Configuration - Panasonic Switch-M12PWR Operation Manual

4.7.6.a. Traffic Class Configuration
On the Quality of Service Configuration Menu, pressing "T" opens the Traffic
Class Configuration screen, as shown in Fig. 4-7-39. On this screen, you can
set QoS in packets.
PN23129K/PN23129A Local Management System
Quality of Service Configuration -> Traffic Class Configuration Menu
QoS Status: Disabled
Priority Traffic Class
-------- -------------
0
1
2
3
4
5
6
7
-------------------------------- <COMMAND> -----------------------------------
[S]et QoS Status
Set Priority-Traffic Class [M]apping
Scheduling Method [C]onfig.
Command>
Enter the character in square brackets to select option
Screen Description
QoS Status:
Priority
Traffic Class
Available commands are listed below.
S Switch enabled/disabled of the QoS function.
Press"S" to change the command prompt to "Enable or Disable QoS (E/D)>." To
enable the QoS function, press "E." To disable it, press "D."
M Assign priority (Traffic Class) to a priority value of IEEE802.1p.
Press "M" to change the command prompt to "Enter Priority (E/D)>." Enter a
priority value (0 to 3) to be assigned. Then, the command prompt changes to
"Enter traffic class for priority #>." Enter Traffic Class (0 to 7).
C Move to the screen for configuring a scheduling method.
Press "C" to change the screen to Scheduling Method. Refer to the section 4.7.6.b
for how to set.
Q Return to the previous menu.
1
0
2
3
4
5
6 0: Lowest
7 7: Highest
[Q]uit to previous menu
Fig. 4-7-39 Traffic Class Configuration
Displays the status of QoS function using IEEE802.1p.
Enabled QoS is enabled.
Disabled QoS is disabled. (Factory default setting)
Displays a priority value in a packet tag.
Displays the packet priority.
152