Panasonic Switch-M12PWR Operation Manual page 42

Available commands are listed below.
S Enable/disable the trap receiver.
Press "S." The command prompt changes to "Enter manager entry number>."
Enter an entry number for the trap receiver you wish to configure. Then, the
command prompt changes to "Enable or Disable Trap Receiver (E/D)>." Press "E"
to enable the SNMP manager. Press "D" to disable it.
I Set an IP address for the trap receiver.
Press "I." The command prompt changes to "Enter manager entry number>."
Enter an entry number for the trap receiver you wish to configure. Then, the
command prompt changes to "Enter IP address for trap receiver>." Enter the IP
address.
D Configure the trap sending settings when the link status changes.
Press "D." The screen changes to the Enable/Disable Individual Trap Menu.
For configuration details, refer to the next section (4.6.3.c).
T Configure the trap type.
Press "T." The command prompt changes to "Enter manager entry number>."
Enter an entry number for the trap receiver you wish to configure. Then, the
command prompt changes to "Enter the selection>." Press "1" to select SNMPv1
traps. Press "2" to select SNMPv2 traps.
C Set a community name for a trap receiver.
Press "C." The command prompt changes to "Enter manager entry number>."
Enter an entry number for a trap receiver you wish to configure. Then, the
command prompt changes to "Enter community name for trap receiver>." Enter
a community name.
Q Return to the previous menu.
42