Table of Contents
Advertisement
Available commands are listed below.
N
Show the next page.
Press "N" to go to the next page.
V
Show the previous page.
Press "V" to go to the previous page.
B
Set the number of terminals that can be authenticated by the port.
Press "B." The command prompt changes to "Enter the number of supplicant >."
Enter an integer between 1 and 512.
P
Set the port number.
Press "P." The command prompt changes to "Enter port number>." Enter the port
number you wish to configure.
C
Set the operation mode for authentication requests.
Press "D." The command prompt changes to "Select Administrative Control
Direction, Both or IN? (B/I)>." Press "B" to disable packet sending and receiving by
this Switching Hub. Press "I" to disable packet receiving by this Switching Hub.
Y
Not available for MAC Based mode
D
Set the communication conditions in unauthorized status.
Press "D." The command prompt changes to "Select Administrative Control
Direction, Both or IN? (B/I)>." Press "B" to make an authentication request for
both packet sending and receiving by this Switching Hub. Press "I" to make an
authentication request for only packet sending from this Switching Hub.
T
Set the time to wait before requesting for a reattempt of authentication.
Press "T." The command prompt changes to "Enter Transmission Period>." Enter an
integer between 1 and 65535 (seconds).
L
Set the timeout for the client
Press "L." The command prompt changes to "Enter Supplicant Timeout value>."
Enter an integer between 1 and 65535 (seconds).
O
Set timeout for the authentication server.
Press "O." The command prompt changes to "Enter Server Timeout>." Enter an
integer between 1 and 65535 (seconds).
X
Set the maximum number of reattempts of authentication.
Press "X." The command prompt changes to "Enter Max request count>." Enter the
maximum number of reattempts with an integer between 1 and 10.
U
Set the time to wait before reattempting a failed authentication.
Press "U." The command prompt changes to "Enter Quiet Period>." Enter an
integer between 1 and 65535 (seconds).
G
Not available for MAC Based mode
E
Set the periodic re-authentication time interval.
Press "E." The command prompt changes to "Enter re-authentication Period>."
Enter an integer between 1 and 65535 (seconds).
A
Enable/disable periodic re-authentication.
Press "A." The command prompt changes to "Select Per port or MAC address
(P/M) >." Press "P" to configure the entire port. Press "M" to configure each MAC
address individually. If you press "P," the command prompt changes to "Enable or
Disable re-authentication ?(E/D) >." Press "E" to enable re-authentication. Press "D"
to disable it. If you press "M," the command prompt changes to "Enter supplicant
MAC address >." Enter the MAC address of the supplicant you wish to configure.
Then, the command prompt changes to "Enable or Disable
re-authentication?(E/D)>." Press "E" to enable re-authentication. Press "D" to
disable it.
165
Advertisement
Table of Contents
