4.7.9.f.
EAP-Request Configuration Menu
On the 802.1x Access Control Configuration screen, pressing "E" opens the
EAP-Request Configuration Menu as shown in Fig. 4-7-50. On this screen,
you can configure EAP Request sending in MAC-based access control mode.
PN23129K/PN23129A Local Management System
802.1x Access Control Configuration -> EAP-Request Configuration
[E]AP-Request Port Configuration
[U]nauthorized MAC Address Table
[Q]uit to previous menu
Notes: EAP-Request Function is supported for MAC Based Access Control only
Command>
Enter the character in square brackets to select option
Note: Enable this function if you use Windows XP/2000 or other supplicant
that does not send EAPOL Start frames.
Fig. 4-7-50 EAP-Request Configuration
176