Table of Contents
Advertisement
Available commands are listed below.
N
Display the next page.
Press "N" to change the display to the next page.
P
Display the previous page.
Press "P" to change the display to the previous page.
I
For setting priority of each port in the Switching Hub
Press "I" to change the command prompt to "Select port number to be changed>."
Enter a port number. Then, "Enter priority for port #>" is displayed. Enter a
number from 0 to 255 in a multiple of 16.
C
Set a cost of each port.
Press "C" to change the command prompt to "Select port number to be
changed>." Enter a port number. Then, "Enter path cost for port #>" is displayed.
Enter a number from 1 to 200000000.
S
Set enable/disable of the spanning tree of each port.
Press "S" to change the command prompt to "Select port number to be changed>."
Enter a port number. Then, "Enable or Disable STP for port # (E/D)>" is displayed.
If the spanning tree is used, press "E." If not, press "D."
G
Set enable/disable of the BPDU guard of each port.
Press "G" to change the command prompt to "Select port number to be
changed>." Enter a port number. Then, "Enable or Disable BPDU guard for port #
(E/D)>" is displayed. If the BPDU guard is used, press "E." If not, press "D."
E
Set enable/disable of auto-recovery of BPDU guard.
Press"E" to change the command prompt to "Enable or Disable BPDU Guard
Recovery (E/D)>." If the auto-recovery of BPDU guard is used, press "E." If not,
press "D."
T
Set the time to auto-recovery.
Press "T" to change the command prompt to "Enter Recovery Timer>." Enter the
time in a range designated in black at the bottom of the screen.
Q
Return to the previous menu.
110
Advertisement
Table of Contents
