Table of Contents
Advertisement
Available commands are listed below.
I
Set the Out-Profile index number.
Press "I" to change the command prompt to "Enter Out-Profile action index>."
Enter 1 to 65535 for index number.
D
Set deny/permit of packet.
Press "D" to change the command prompt to "Select Deny/Permit (1-2)>." To
deny, select "1." To permit, select "2."
C
Set the committed rate.
Press "C" to change the command prompt to "Enter committed rate>." Enter
from 1 to 1000 for committed rate.
B
Set the burst size.
Press "B" to change the command prompt to "Select burst size (1-5)>." If the
traffic burst size exceeding the committed rate is 4K, press "1." If 8K, press "2." If
16K, press "3." If 32K, press "4." If 64K, press "5."
S
Set DSCP value to be marked.
Press "S" to change the command prompt to "Enter DSCP value>." Enter from 0
to 63 for DSCP value.
A
Apply the set contents. If not applied here, setting is not enabled.
Q
Return to the previous menu.
144
Advertisement
Table of Contents
