Panasonic Switch-M12PWR Operation Manual page 157

Available commands are listed below.
D Enable/disable the unknown unicast storm control.
Press "D." The command prompt changes to "Enter port number>." Enter a port
number you wish to specify. Then, the command prompt changes to "Enable or
Disable DLF storm control status (E/D)>." Press "E" to enable the unknown unicast
storm control, and press "D" to disable it.
B Enable/disable the broadcast storm control.
Press "B." The command prompt changes to "Enter port number>." Enter a port
number you wish to specify. Then, the command prompt changes to "Enable or
Disable broadcast storm control status (E/D)>." Press "E" to enable the broadcast
storm control, and press "D" to disable it.
M Enable/disable the multicast storm control.
Press "M." The command prompt changes to "Enter port number>." Enter a port
number you wish to specify. Then, the command prompt changes to "Enable or
Disable multicast storm control status (E/D)>." Press "E" to enable the multicast
storm control, and press "D" to disable it.
T Set the threshold of the number of packets per second.
Press "T." The command prompt changes to "Enter port number>." Enter a port
number you wish to specify. Then, the command prompt changes to "Enter
threshold value." Enter the threshold of the number of packets per second
between 0 and 262143.
Q Return to the previous menu.
157