Unpacking And Mounting The Ex2300 Switch; Unpacking An Ex2300 Switch - Juniper EX2300 Series Hardware Manual

Unpacking and Mounting the EX2300 Switch

IN THIS SECTION
Unpacking an EX2300 Switch | 101
Parts Inventory (Packing List) for an EX2300 Switch | 102
Register Products-Mandatory to Validate SLAs | 103
Installing and Connecting an EX2300 Switch | 104
Mounting an EX2300 Switch | 105
Mounting an EX2300 Switch on a Desk or Other Level Surface | 106
Mounting an EX2300-C Switch Under a Desk or Other Level Surface by Using Screws | 108
Mounting an EX2300 Switch on Two Posts of a Rack or Cabinet | 113
Mounting an EX2300 Switch on Four Posts of a Rack or Cabinet | 116
Mounting an EX2300 Switch on a Wall | 119
Mounting an EX2300-C Switch on or Under a Surface Made of Ferrous Material | 127
Mounting an EX2300 Switch in a Recessed Position in a Rack or Cabinet | 132

Unpacking an EX2300 Switch

EX2300 switches are shipped in a cardboard carton, secured with foam packing material. The carton
also contains an accessory box.
CAUTION: EX2300 switches are maximally protected inside the shipping carton. Do
not unpack the switches until you are ready to begin installation.
To unpack the switch:
1. Move the shipping carton to a staging area as close to the installation site as possible, but where you
have enough room to remove the system components.
2. Position the carton so that the arrows point up.
3. Open the top flaps on the shipping carton.
4. Remove the accessory box and verify the contents in it against the parts inventory on the label
attached to the carton.
101