Paper Source/Feeding - Ricoh fi-8040 Operator's Manual

Paper Source/Feeding

● Retry Paper Feeding (page 288)
● Multifeed Detection (page 288)
Multifeed Detection Area (page 290)
●
Intelligent Multifeed Detection (page 291)
●
Manual Feeding (page 293)
●
● High Altitude Mode (page 294)
Retry Paper Feeding
Specify the number of feeding retries when a document is not fed from the ADF paper chute
(feeder).
Paper Feeding Retries
The factory default setting is "4".
Multifeed Detection
Multifeed is an error that occurs when two or more sheets are overlapped and fed at once.
Configure the settings to detect overlapped documents during a scan.
Overlapped documents are detected with the ultrasonic sensor or according to the difference
in length of the documents.
When overlapped documents are detected, an error message is displayed and the scan stops. If
documents are overlapped within 30 mm from the leading edge, they are not detected as
overlapped.
ATTENTION
When the feed mode of the scanner is set to [Manual - Single], document overlapping will
not be detected.
Manual Single Mode is the mode for scanning a document folded in half or a multi-layered
document such as an envelope. Therefore, even if the setting for detecting overlapped
documents is enabled, such documents are not detected as overlapped documents.
Detection Method
Specify a method to detect overlapped documents.
● Does not detect
Does not detect overlapped documents.
This is the factory default setting.
● Check Overlapping (Ultrasonic)
Detects overlapped documents with the ultrasonic sensor.
When this is selected, you can specify the following two options:
288
Scanner Settings (Touch Screen)