Invalid Command - Ricoh fi-8040 Operator's Manual

Example:
Outside of the document may have been scanned because the scanned document is shorter than
the specified paper size.
In this case, take one of the following measures, and then scan again.
● Load a document of the specified paper size in the ADF paper chute (feeder).
● Change the scan settings so that the scanning area is set inside of the document.
ATTENTION
Ways to designate the scanning area differ depending on scanner drivers and image scanning
applications. For details, refer to the help for your scanner driver and the manual/help for your
image scanning application.

Invalid Command

The command was ended abnormally.
There may be a problem with the USB cable connection.
● Make sure that the USB cable is connected properly.
● Turn the scanner off then back on.
If the problem still persists, write down the error code, check each item in
Scanner Service Provider (page 248) and then contact the distributor/dealer where you purchased
193
Troubleshooting
Before You Contact the