Processing A Job (Directscan) - Ricoh fi-8040 Operator's Manual

Processing a Job (DirectScan)

This section explains about the basic flow of processing a job to start a scan when using DirectScan.
Before processing a job with the scanner, you need to configure the settings for the job.
You can register the way to send images from a scanner (saving them to a folder or sending them by
email) and the scan settings as a job, according to the intended use of images.
1
Turn on the scanner.
For details, refer to
2
Confirm that the following main screen is displayed on the touch screen.
HINT
If the above screen is not displayed, refer to
(page 411) to change the main screen.
3
Load a document in the ADF paper chute (feeder).
How to Turn the Power ON (page
81
61).
How to Change the Way the Scanner Is Used
How to Perform a Basic Scan