Ricoh fi-8040 Operator's Manual page 347

[Clear overlap pattern] check box
Select this to erase the overlap patterns that were memorized in Auto mode.
By selecting this, you can erase the overlap patterns that were memorized in Auto mode.
You can erase overlap patterns that were not supposed to be memorized, but be careful
with this operation because all memorized patterns will be erased.
The check box is cleared for the factory default settings.
[Memorize the overlap pattern automatically] check box
For Auto mode 1 or Auto mode 2, you can manually switch whether or not to memorize an
overlap pattern on the touch screen when overlapped documents are detected.
Select this to change the default setting to enable in order to memorize the overlap pattern
when overlapped documents are detected.
The check box is cleared for the factory default settings.
The overlap pattern is memorized when the [Scan] button on the scanner is pressed for the
next scan.
For details about the function that memorizes an overlap pattern, refer to
to Detect Certain Overlap Patterns (page
Remember overlap patterns at power-off
You can specify whether or not to keep the overlap pattern upon turning the power off.
When [Remember] is selected, eight of the most recent overlap patterns for Auto mode 1
and one overlap pattern for Auto mode 2 can be used the next time the scanner is powered
on.
The factory default setting is [Do not remember].
HINT
● When the setting for using the Carrier Sheet is enabled in the scanner driver, [Intelligent
Multifeed Function] is disabled.
● The settings can also be configured on the touch screen.
● The overlap patterns can also be cleared by pressing the [Clear] button for [Overlap pattern]
in the [Intelligent Multifeed Detection] screen on the touch screen.
The screen can be displayed in the following procedure:
→ [Scanner Settings] → [Paper Source/Feeding] → [Intelligent Multifeed Detection]
Scanner Settings (Software Operation Panel)
126).
347
Configuring Not