Ricoh fi-8040 Operator's Manual page 342

Range: 0 to 510 mm, in 2 mm increments, Start ≦ End
The factory default setting is "0".
HINT
● When the start and end positions are both "0", overlapped documents are detected in the
whole document regardless of the setting for [Selected range].
● To disable the detection of overlapped documents for the whole document, select [Disable]
for [Selected range], and set the start position to "0" and the end position to equal the
document length or longer.
● If the start position is set at a length longer than the document length, overlapped
documents are detected in the whole document when [Disable] is selected for [Selected
range], and overlapped documents are not detected anywhere in the whole document when
[Enable] is selected for [Selected range].
● To detect overlapped documents, the area must be at least 5 mm in length.
Configure the setting so that the value of the end position minus the start position is 6 mm
or more.
● You can also set the start position and the end position by the following methods:
- On the window for specifying the detection area, draw a square by dragging the mouse
pointer.
- On the window for specifying the detection area, drag the handles that indicate the start
position and the end position.
● For examples of the overlapping detection area settings, refer to
for the Area to Detect the Overlapping of Documents (page
Scanner Settings (Software Operation Panel)
343).
342
Examples of the Settings