Activating Sto Via Profisafe And F-Di; Defining The Commissioning Method - Siemens SINAMICS G120 Function Manual

4.5.3

Activating STO via PROFIsafe and F-DI

Procedure
● Go online with STARTER.
● In STARTER, call up the screens displaying the fail-safe functions and click on "Change
4.5.3.1

Defining the commissioning method

●
●
●
●
Safety Integrated Function Manual, SINAMICS G120 and G120C
Function Manual, 01/2011, FW 4.4, A5E03052391B AB
settings":
①
Set "STO via PROFIsafe and Terminal".
②
If you require the status signal "STO active" in your higher-level controller,
interconnect it accordingly.
③
Enter the same PROFIsafe address as a hexadecimal value that you defined in the
hardware configuration (F_Dest_Add).
See section: Configuring communication in STEP 7 (telegram 30) (Page 100).
④
Click the button to set the STO.
Commissioning
4.5 Basic Safety
117