Removing A Qfx10002 From A Rack - Juniper QFX10002 Hardware Manual

RELATED DOCUMENTATION
request system reboot
request vmhost reboot

Removing a QFX10002 from a Rack

Before removing a QFX10002 from a rack:
Ensure that you have the following parts and tools available:
• A Phillips (+) screwdriver, number 2 or number 3, depending on the size of your rack mounting
screws, for mounting the QFX10002 on the rack.
If you need to relocate an installed QFX10002 device, use the procedure described in this topic.
NOTE: When you remove multiple devices from a rack, remove the device in the top of the rack
first and proceed to remove the rest of the devices from top to bottom to avoid toppling the
rack.
• Ensure that the rack is stable and secured to the building.
• Ensure that there is enough space to place the removed QFX10002 in its new location and along the
path to the new location.
• Read "General Safety Guidelines and Warnings" on page
• Powered off the device, see
• Disconnect the power cords.
• Ensure that you have disconnected any cables or wires attached to the QFX10002 switch ports.
To remove a QFX10002 from a rack or cabinet:
1. Position a mechanical lift under the device. If a mechanical lift is not available, have two people
support the weight of the switch while another person uses the screwdriver to remove the front
mounting screws that attach the chassis mounting brackets to the rack or cabinet.
2. Remove the QFX10002 from the rack.
3. Use the screwdriver to remove the mounting screws that attach the mounting blades attached to the
rear of the rack or cabinet.
"Powering Off a QFX10002" on page
164.
139.
142