Juniper QFX10002 Hardware Manual page 43

switch. To determine the Junos release level, use the show version command. To determine the CPLD of
your switch, use the show chassis firmware command. For example:
root@> show chassis firmware
Part
FPC 0
root@>
See Table 13 on page 34
Table 13: Network Port LEDs on QSFP+ Ports on a QFX10002
Color State
Unlit Off
Green On steadily
Slow blinking (250 ms on
and 1750 ms off)
Blinking (500 ms on and
500 ms off)
Amber On steadily
Type Version
U-Boot ***
loader FreeBSD/i386 bootstrap loader 1.2
BIOS V0018.2U
EC FPGA 2.3
MAIN_CPLD 1.10
MEZZ_CPLD 1.10
RE FPGA 2.4
for how to interpret the QSFP+ LEDs.
Description
The port is administratively disabled, there is no power, the
link is down, or a transceiver is not present. All sub-
channels are disabled.
A link is established. When channelized, all sub-channels
are up. When not channelized, it indicates no activity.
The beacon function was enabled on the port.
When channelized, all four channels are up and active.
When not channelized, it indicates the port is up and active
in either 40-Gigabit or 100-Gigabit mode.
For Junos Release 15.1X53-D21 or later and CPLD version
V1.16 or later:
One or more breakout connections (sub-channels) are up.
However not all sub-channels are up and there is no port
activity.
34