Qfx10002 Installation Safety Guidelines - Juniper QFX10002 Hardware Manual

b. "Connecting a QFX10002 to a Management Ethernet Device" on page 108

QFX10002 Installation Safety Guidelines

IN THIS SECTION
General Installation Safety Guidelines | 98
QFX10002 Chassis Lifting Guidelines | 98
Observe the following guidelines before and during QFX10002 installation:
General Installation Safety Guidelines
Before installing or moving the QFX10002, verify that the intended site meets the specified power,
environmental, and clearance requirements. See the following documentation:
• "QFX10002 Site Preparation Checklist" on page 64
• "QFX10002 Clearance Requirements for Airflow and Hardware Maintenance" on page 69
• "QFX10002 Rack Requirements" on page 72
• "QFX10002 Cabinet Requirements" on page 74
• "QFX10002 Environmental Requirements and Specifications" on page 66
• "QFX10002 AC Power Specifications" on page 52
57
QFX10002 Chassis Lifting Guidelines
The weight of a fully-loaded QFX10002-72Q is approximately 68.6 lbs (31.1 kg) with AC power supplies
and 67.8 lbs (30.8 kg) with DC power supplies installed. The weight of a QFX10002-36Q is 54 lbs (24.5
kg). (Observe the following guidelines for lifting and moving a QFX10002:
CAUTION: If you are installing the QFX10002 above 60 in. (152.4 cm) from the floor,
remove the power supplies and fan modules before attempting to install the switch.
or "QFX10002 DC Power Specifications" on page
98