Juniper QFX10002 Hardware Manual page 113

4. Align the holes in the mounting rail with the holes on one side of the chassis. See
104 for the proper position and alignment of the rail for the QFX10002 device.
Figure 34: Attaching Mounting Rails to the QFX10002 Switch Chassis
5. Attach the mounting rail to the switch using 11 mounting screws. You may either use the screws
from the mounting kits or the screws that were removed from the cover. Tighten the screws.
6. Repeats steps 4 and 5 on the opposite side of the switch. A few mounting screws are extra.
7. Either use a mechanical lift or have two people grasp both sides of the switch, lift it, and position it
in the rack so that the front bracket is aligned with the rack holes.
8. Have a another person secure the front of the switch to the rack using 8 chassis screws (and cage
nuts and washers if your rack requires them.) Tighten the screws. See
example of connecting the mounting rails and blades.
Figure 35: Attach Switch to Rack
9. Continue to support the switch while sliding the rear mounting-blades into the channel of the side
mounting-rails and securing the blades to the rack. Use the 8 mounting screws (and cage nuts and
washers if your rack requires them) to attach each blade to the rack. Tighten the screws. See
35 on page 104.
10. Ensure that the switch chassis is level by verifying that all the screws on the front of the rack are
aligned with the screws at the back of the rack.
31
Figure 34 on page
Figure 35 on page 104 for an
Figure
104