Juniper QFX10002 Hardware Manual page 23

Table 6: QFX10002-36Q Port Capacities
Per Port Group
1 x100 Gbps
3 x 40 Gbps
12 x 10 Gbps
The second and sixth port in each 6XQSFP+ socket can be configured to support:
• 100-Gigabit Ethernet using 28-Gbps QSFP28 optical transceivers and 100-Gbps active optical cables
(AOCs). When a QSFP28 transceiver is inserted into the ports marked with a fine black line
underneath the socket and the port is configured for 100-Gigabit Ethernet, the two adjacent ports
are disabled and the QSFP28 is enabled for 100-Gigabit Ethernet.
• 40-Gigabit Ethernet using QSFP+ optical transceivers or 40-Gbps direct attach copper (DAC) cables.
• 10-Gigabit Ethernet using DAC breakout cables (DACBO). When configured for channelization, a
breakout cable converts the 40-Gigabit Ethernet port into 4 independent 10-Gigabit Ethernet ports.
The two adjacent QSFP+ ports in the port group are also configured for channelization at the same
time. You cannot configure a single port for channelization.
Network Ports
Each of the 12 QSFP28 ports support:
• 100-Gigabit Ethernet QSFP28 transceivers
• 100-Gigabit Ethernet active optical cables (AOCs)
• 40-Gigabit Ethernet QSFP+ transceivers
• 40-Gigabit Ethernet QSFP+ DAC cables
• 40-Gigabit Ethernet QSFP+ to 10-Gigabit Ethernet SFP+ direct attach copper breakout (DACBO)
cables
The remaining ports support:
• 40-Gigabit Ethernet QSFP+ transceivers
• 40-Gigabit Ethernet QSFP+ DAC cables
Per Switch
12 x 100 Gbps
36 x 40 Gbps
144 x 10 Gbps
14