Rebooting A Qfx10002; Powering Off A Qfx10002 - Juniper QFX10002 Hardware Manual

Powering Off a QFX10002 | 139

Rebooting a QFX10002

If you need to restart your QFX10002, use the appropriate CLI operational command for your model.
For models QFX10002-36Q and QFX10002-72Q, use the request system reboot command. The request
system reboot is not supported on the QFX10002-60C platform. Starting from Junos OS Release 19.1R1
and later, the request system reboot command is deprecated from the QFX10002-60C switch platform.
Instead, use the request vmhost reboot command to reboot the QFX10002-60C device.
Powering Off a QFX10002
Before you power off a QFX10002:
• Ensure that you have taken the necessary precautions to prevent electrostatic discharge (ESD)
damage. See "Prevention of Electrostatic Discharge Damage" on page
• Ensure that you do not need to forward traffic through the switch.
NOTE: Use the following procedure to turn off power on a QFX10002.
Ensure that you have the following parts and tools available to power off the switch:
• An ESD grounding strap
• An external management device such as a PC
• An RJ-45 to DB-9 rollover cable to connect the external management device to the console port
To power off a QFX10002:
1. Connect to the switch using one of the following methods:
• Connect a management device to the console (CON) port on a QFX10002 by following the
instructions in "Connecting a QFX Series Device to a Management Console" on page
• Connect a management device to one of the two management (MGMT ) ports by following the
instructions in "Connecting a QFX10002 to a Management Ethernet Device" on page
189.
109.
108.
139