Removing A Qfx10002 From A Rack - Juniper QFX10002 Hardware Manual

See Also
Related
Documentation

Removing a QFX10002 from a Rack

Copyright © 2019, Juniper Networks, Inc.
DC power supply—Loosen and the thumbscrews securing the DC power connector
on the power source cables. Remove the power source cables from the power
supply.
Uncable the switch before removing it from the rack or cabinet.
6.
Connecting the QFX10002 on page 96
request system reboot
request vmhost reboot
If you need to relocate an installed QFX10002 device, use the procedure described in
this topic.
NOTE: When you remove multiple devices from a rack, remove the device in
the top of the rack first and proceed to remove the rest of the devices from
top to bottom to avoid toppling the rack.
Before removing a QFX10002 from a rack:
Ensure that the rack is stable and secured to the building.
Ensure that there is enough space to place the removed QFX10002 in its new location
and along the path to the new location.
Read "General Safety Guidelines and Warnings" on page
Powered off the device, see
Disconnect the power cords.
Ensure that you have disconnected any cables or wires attached to the QFX10002
switch ports.
Ensure that you have the following parts and tools available:
A Phillips (+) screwdriver, number 2 or number 3, depending on the size of your rack
mounting screws, for mounting the QFX10002 on the rack.
To remove a QFX10002 from a rack or cabinet:
Position a mechanical lift under the device. If a mechanical lift is not available, have
1.
two people support the weight of the switch while another person uses the screwdriver
to remove the front mounting screws that attach the chassis mounting brackets to
the rack or cabinet.
Remove the QFX10002 from the rack.
2.
"Powering Off a QFX10002" on page
Chapter 4: Maintaining Components
144.
125.
127