Connecting A Qfx10002 To A Management Ethernet Device; Figure 37: Connecting A Grounding Cable To The Qfx10002 - Juniper QFX10002 Hardware Manual

QFX10002 Switch Hardware Guide
See Also

Connecting a QFX10002 to a Management Ethernet Device

98

Figure 37: Connecting a Grounding Cable to the QFX10002

Secure the grounding lug to the protective earthing terminal with the washers and
3.
screws.
Dress the grounding cable and ensure that it does not touch or block access to other
4.
device components and that it does not drape where people could trip over it.
General Safety Guidelines and Warnings on page 144
Grounded Equipment Warning on page 155
You can monitor and manage the QFX10002 using a dedicated management channel.
The QFX10002 has two management ports: a 10/100/1000BASE-T RJ-45 port for copper
connections and a 1-Gigabit SFP ports for fiber connections. Use the management ports
to connect the QFX10002 to a network for out-of-band management.
NOTE: You cannot use the management ports to perform the initial
configuration of the QFX10002. You must configure the management ports
before you can successfully connect to the QFX10002 using these ports. See
"Configuring a QFX10000" on page 106.
Copyright © 2019, Juniper Networks, Inc.