Using The Bypass Tray - Muratec Fax Machine Installation Manual

Using the bypass tray

If you want to copy onto the transparency film, thick paper, envelopes or post cards,
use the bypass tray.
Note: Also, your machine's multi-purpose cassette (1st cassette) can hold these
papers.
Note: You can set the paper in the bypass tray with a length of 3.6 to 11.7 (91 to
297 mm) and width of 5.5 to 17 (140 to 432 mm).
Important: If loading transparency (OHP) film, be sure that the film does not
have paper backing and/or a leading strip. If it does, remove the paper
backing and/or strip before inserting.
1
Set the document in the or on the
ADF
2
Open the bypass tray.
3
Place a sheet of paper face down on the
bypass tray. Then align the paper guides
to the sheet's edges and insert the sheet
until it comes to a stop.
Note: You can place only one sheet on
the bypass tray at a time.
4
Press [Ppr.Size].
If you're using the standard type of paper (plain paper), skip to step 7.
Otherwise, proceed to step 5.
5
Press [Ppr.Type].
6
Select the paper type using the cursor key.
Then press [Enter].
.
FBS
7
Select the paper size.
When using the standard paper size:
(1) Select the paper size using the cursor key.
(2) Press [Enter].
When using the non standard paper size:
(1) Press [Other].
(2) Select the paper size using the cursor key.
(3) Press [Enter].
When using the special sized paper:
(1) Press [Other].
(2) Select "Custom" using the cursor key.
Note: You can register three types of special
size as you want.
(3) Press [Enter].
(4) Enter the horizontal and vertical size of the
paper using the numeric keypad.
Note: You can also enter the paper size using
and of the cursor key.
Note: To change Horizontal/Vertical, use
and of the cursor key.
(5) Press [Enter].
8
Press to begin the copying process.
START
Basic copy
2.7