Table of Contents
Advertisement
TalkAnytime User Guide
Field Name
FXS Ground/Loop Start
Supervision Parameters
Tone Detection
(Enable)
Available
Tones (List)
Answer Tones
(List)
ISDN Parameters
Field Name
Enable
ISDN-PRI
Terminal/
Network
E1 Parameter Definitions (cont'd)
Values
Description
Y/N
After a specified tone (chosen
from the Available Tones list)
coming from the PBX is
stopped, the FXS interface will
send the 'connect' signal to the
calling party.
List from which tones can be
Busy Tone, Dial
chosen to signal call answer.
Tone, Reorder Tone
Survivability Dial
Tone, Unobtainable
Tone
Currently chosen call-answer
Busy Tone, Dial
supervision tone.
Tone, Reorder Tone
Survivability Dial
Tone, Unobtainable
Tone
Values
Description
Y/N
If digital connection is ISDN-
PRI type, this box should be
checked. When ISDN is
enabled, the "CAS Protocols"
field is grayed out (ISDN has its
own signaling method).
either
When "Terminal" is selected, it
"Terminal" or
indicates that the TalkAnytime
"Network"
should emulate the subscriber
(terminal) side of the digital
connection. When "Network"
is selected, it indicates that the
TalkAnytime should emulate
the central office (network) side
of the digital connection.
Setting used for TalkAnytime must
be opposite to the setting used in
the PBX. For example, if the PBX is
set to "Terminal," then the
TalkAnytime must be set to
"Network."
99
Technical Configuration
Advertisement
Table of Contents
