Phone/Ip Starter Configuration - Multitech TalkAnytime TA2410 User Manual

TalkAnytime Quick Start Instructions

Phone/IP Starter Configuration

Full details here: Technical Configuration chapter in User Guide
1. Open the TalkAnytime program:
Start | TalkAnytime xxx | Configuration.
Note: If you used the "Work-Around" on page 27 to operate using the TalkAnytime web GUI only, skip to step 4E.
2. Go to Configuration | Ethernet/IP. Enter the IP parameters for your TalkAnytime unit. Activate Packet
Prioritization (802.1p) if desired. For details, see the "Technical Configuration" chapter of the User Guide.
3. Do you want to configure and operate the TalkAnytime unit using the web browser GUI? (It has the
same functionality as the local Windows GUI, but offers remote access.)
If NO, skip to step 5. If YES, continue with step 4.
4. Web Browser GUI Setup (Optional). To do configuration and operation procedures using the web
browser GUI, you must first set it up. To do so, follow these steps. (The browser used must be Internet
Explorer 6.0 or above; or Netscape 6.0 or above; or FireFox 1.0 or above.)
A. Be sure an IP address has been
assigned to the TalkAnytime unit
(this must be done in the
TalkAnytime Windows GUI).
B. Save Setup in Windows GUI.
C. Close the TalkAnytime Windows
GUI.
D. Install Java program from
TalkAnytime product CD.
(Must be Java Runtime
Environment 1.4.2_01 or above.)
NOTE: Required on first use of
Web Browser GUI only.
Need more
info?
Once you've begun using the web browser GUI, you can go back to the TalkAnytime Windows GUI
at any time. However, you must log out of the web browser GUI before using the TalkAnytime
Windows GUI.
5. Go to Configuration | Voice/Fax. Select Coder | "Automatic." At the right-hand side of the dialog box,
click OK. If you know any specific parameter values that will apply to your system, enter them. Click
Copy Channel. Select Copy to All. Click Copy. At main Voice/Fax Parameters screen, click OK to exit
from the dialog box.
6. Enter telephone system information.
Go to Configuration | T1/E1/ISDN Parameters. Enter parameters obtained from phone company or PBX
administrator.
7. Go to Configuration | Regional Parameters. Select the Country/Region that fits your situation. Click
OK and confirm. Click OK to exit from the dialog box.
E. Open web browser.
(Note: The PC being used must
be connected to and have an IP
address on the same IP network
that the TalkAnytime is on.)
F. Browse to IP address of
TalkAnytime unit.
G. If username and password have
been established, enter them
when prompted by the
TalkAnytime unit.
H. Use web browser GUI to
configure or operate the
TalkAnytime unit.
See "Web Browser Interface" in Operation &
Maintenance chapter of
User Guide
(on CD).
31
Phone/IP Starter Config.