Multitech TalkAnytime TA2410 User Manual page 108

Technical Configuration
Field Name
Country
Selection for
Built-In
Modem
User Defined Tones fields
Type column
Frequency 1
Frequency 2
Gain 1
Gain 2
Cadence
(msec) On/Off
"Regional Parameter" Definitions (cont'd)
Values Description
TalkAnytime units include a built-in modem. The administrator can dial into this
country name
modem to configure the TalkAnytime unit remotely. The country name values in
this field set telephony parameters that allow the modem to work in the listed
country. This value may be different than the Country/Region value. For
example, a user may need to choose "Europe" as the Country/Region value but
"Denmark" as the Country-Selection-for-Built-In-Modem value.
Name of supervisory tone pair. Cannot be same as name of any standard
alphanumeric
tone pair.
name specified
by user
freq. in Hertz Lower frequency of pair.
Higher frequency of pair.
freq. in Hertz
gain in dB Amplification factor of lower frequency of pair.
+3dB to –31dB This applies to any supervisory tones that the TalkAnytime unit outputs as audio
and "mute" setting to the FXS, FXS, or E&M port. Default: -16dB
gain in dB Amplification factor of higher frequency of pair.
+3dB to –31dB This applies to any supervisory tones that the TalkAnytime unit outputs as audio
and "mute" setting to the FXS, FXO, or E&M port. Default: -16dB
n/n/n/n
On/off pattern of tone durations used to denote supervisory tones specified by
four integer time
user. Supervisory tones relate to answering and disconnection of calls. Although
values in
most cadences have only two parts (an "on" duration and an "off" duration),
milli-seconds;
some telephony cadences have four parts. Most cadences, then, are expressed as
zero value for
two iterations of a two-part sequence. Although this is redundant, it is necessary
dial-tone
to allow for expression of 4-part cadences.
indicates
continuous tone
108
TalkAnytime User Guide