Table of Contents
Advertisement
TalkAnytime Quick Start Instructions
Inbound Phonebook
1. Open the TalkAnytime program.
( Start | TalkAnytime xxx | Configuration )
2. Go to Phone Book | Inbound Phonebook | Add Entry.
3. In the "Remove Prefix" field, enter the PBX extension to which you want to direct the incoming
TalkAnytime calls.
4. In the "Add Prefix" field, enter the same digits as were entered in the "Remove Prefix" field.
5. In the "Channel Number" field, enter "Hunting." A "hunting" value means the TalkAnytime unit will
assign the call to the first available channel.
If desired, specific channels can be assigned to specific incoming calls (i.e., to any set of calls received
with a particular incoming dialing pattern).
6. In the "Description" field, enter an identifier (letters and/or digits) that describes the destination of the
incoming TalkAnytime calls. The identifier entered in this field must match the identifier used in the
field of the TalkAnytime URL (see the "TalkAnytime URL Configuration" section below). The
Service
description should make the routing of calls easy to understand. (40 characters max.)
7. Repeat steps 2-6 for each inbound phonebook entry. As noted above, each channel of the TalkAnytime
unit can be configured separately, have its own values in the "Remove Prefix" and "Add Prefix" fields
and its own "Description" value. Or all channels can be configured alike. When all entries are complete,
go to step 8.
8. Click OK to exit the inbound phonebook screen.
9. Click on Save Setup. Highlight Save and Reboot. Click OK.
Your starter inbound phonebook configuration is complete.
33
Phonebook Configuration
Advertisement
Table of Contents
