Multitech TalkAnytime TA2410 User Manual page 77

TalkAnytime User Guide
Field Name
IP Parameter fields
Gateway Name
Enable DHCP
IP Address
IP Mask
Gateway
DiffServ
Parameter
fields
Call Control PHB
Voip Media PHB
Ethernet/IP Parameter Definitions (cont'd)
Values Description
alphanumeric
Descriptor of current voip unit to distinguish it from other
units in system.
Y/N
Dynamic Host Configuration Protocol is a method for
assigning IP address and other IP parameters to computers
disabled by
on the IP network in a single message with great flexibility.
default
IP addresses can be static or temporary depending on the
needs of the computer.
4-places, 0-255 The unique LAN IP address assigned to the
TalkAnytime unit.
4-places, 0-255 Subnetwork address that allows for sharing of IP
addresses within a LAN.
4-places, 0-255. The IP address of the device that connects your
TalkAnytime to the Internet.
DiffServ PHB (Per Hop Behavior) values pertain to a differential
prioritizing system for IP packets as handled by DiffServ-
compatible routers.
There are 64 values, each with an elaborate technical
description. These descriptions are found in TCP/IP standards RFC2474,
RFC2597, and, for present purposes, in RFC3246, which describes the value
34 (34 decimal; 22 hex) for Assured Forwarding behavior (default for Call
Control PHB) and the value 46 (46 decimal; 2E hexadecimal) for Expedited
Forwarding behavior (default for Voip Media PHB). Before using values
other than these default values of 34 and 46, consult these standards
documents and/or a qualified IP telecommunications engineer.
To disable DiffServ, configure both fields to 0 decimal.
The next page explains DiffServ in the context of the IP datagram.
Value is used to prioritize call setup IP packets.
0 – 63
default = 34
.
0 – 63 Value is used to prioritize the RTP/RTCP audio IP
default = 46 packets.
n
77
Technical Configuration