Multitech TalkAnytime TA2410 User Manual page 32

Phone/IP Starter Config.
Phone/IP Starter Configuration (continued)
8. Go to Configuration | Regional Parameters. In the Country Selection for Built-In Modem field (drop-
down list), select the country that best fits your situation. (This may not be the same as your selection for
the Country/Region field. The selections in the Country Selection for Built-In Modem field entail more
detailed groupings of telephony parameters than do the Country/Region values.) Click OK.
9. Do you want the phone-call logs produced by the TalkAnytime to be sent out by email (to your
Administrator or someone else)?
If NO, skip to step 11.
If YES, continue with step 10.
10. Go to Configuration | SMTP.
SMTP lets you send phone-call log records to the TalkAnytime Administrator by email. Select Enable
SMTP.
You should have already obtained an email address for the TalkAnytime itself (this serves as the
origination email account for email logs that the TalkAnytime can email out automatically).
Enter this email address in the "Login Name" field.
Type the password for this email account. Click OK.
Enter the IP address of the email server where the TalkAnytime's email account is located in the "Mail
Server IP Address" field.
Typically the email log reports are sent to the TalkAnytime Administrator but they can be sent to any
email address. Decide where you want the email logs sent and enter that email address in the "Recipient
Address" field.
Whenever email log messages are sent out, they must have a standard Subject line. Something like
"Phone Logs for TalkAnytime N" is useful. If you have more than one TalkAnytime unit in the building,
you'll need a unique identifier for each one (select a useful name or number for "N"). In this "Subject"
field, enter a useful subject title for the log messages.
In the "Reply-To Address" field, enter the email address of your Administrator.
11. Go to Configuration | Logs.
Select "Enable Console Messages."
To allow log reports by email (if desired), click SMTP. Click OK.
To do logging with a SysLog client program, click on "SysLog Server – Enable" in the Logs screen. To
implement this function, you must install a SysLog client program. For more info, see the "SysLog Server
Functions" section of the Operation & Maintenance chapter of the
12. Go to Save Setup | Save and Reboot. Click OK. This will save the parameter values that you have just
entered.
The TalkAnytime unit's "BOOT" LED will light up while the configuration file is being saved and loaded
into the TalkAnytime. Don't do anything to the TalkAnytime until the "BOOT "LED is off (a loss of
power at this point could cause the TalkAnytime unit to lose the configuration settings you have made).
END OF PROCEDURE.
TalkAnytime Quick Start Instructions
User Guide
32
.