Multitech TalkAnytime TA2410 User Manual page 92

Technical Configuration
Field Name
FXS Ground/Loop Start
Supervision Parameters
Tone Detection
(Enable)
Available
Tones (List)
Answer Tones
(List)
ISDN Parameters
Field Name
Enable
ISDN-PRI
Terminal/
Network
T1 Parameter Definitions (cont'd)
Values Description
Y/N After a specified tone (chosen from the Available Tones
list) coming from the PBX is stopped, the FXS interface
will send the 'connect' signal to the calling party.
List from which tones can be chosen to signal call
Busy Tone, Dial
answer.
Tone, Reorder Tone
Survivability Dial
Tone, Unobtainable
Tone
Currently chosen call-answer supervision tone.
Busy Tone, Dial
Tone, Reorder Tone
Survivability Dial
Tone, Unobtainable
Tone
Values Description
Y/N If digital connection is ISDN-PRI type, this box should be
checked. When ISDN is enabled, the "CAS Protocols"
field is grayed out (ISDN has its own signaling method).
either
When "Terminal" is selected, it indicates that the TalkAnytime
"Terminal" or
unit should emulate the subscriber (terminal) side of the digital
"Network"
connection. When "Network" is selected, it indicates that the
TalkAnytime unit should emulate the central office (network)
side of the digital connection.
Setting used for TalkAnytime unit must be opposite to the
setting used in the PBX. For example, if the PBX is set to
"Terminal," then the TalkAnytime unit must be set to
"Network."
92
TalkAnytime User Guide