Table of Contents
Advertisement
Expansion Cards
Installation
Both the TA2410 and the TA3010 use the same mechanical chassis. This chassis accommodates a second
TalkAnytime circuit card or motherboard module. The add-on module for the TA2410 is the TA24-48
product; the add-on module for the TA3010 is the TA30-60 product.
To install an expansion card into an TA2410 or TA3010, you must:
1. Power down and unplug the TA-2410/3010 unit.
2. Using a Phillips or star-bit screwdriver, remove the blank plate at the rear of the TA-2410/3010 chassis
(see Figure C-1). Save the screw.
3. A power cable for the expansion card (+5V) is already present within the TA-2410/3010 unit. This power
cable has a two-pin "molex" connector. When the rear cover plate has been removed, the cable is accessible
from the rear at the right side of the expansion slot. Locate this connector within the TA-2410/3010. See
Figure C-2.
Power Cable
4. While keeping the power cable out of the way, fit the TA24-48 or TA30-60 card into the grooves of the
expansion slot. Push it in far enough to allow connection of the power cable to the receptacle on the vertical
plate of the expansion card. (See Figure C-2.) Connect the power cable.
Figure C-1: Remove Plate Covering Expansion Slot
Molex Connector
Figure C-2: TA-2410/3010 Chassis (top/rear view)
220
TalkAnytime User Guide
Advertisement
Table of Contents
