Advertisement
RSV4 Factory a-PRC
Component position
in the electrical circuit
diagram
10
9
31
19
33
36
25
Electrical system installation
INTRODUCTION
Scope and applicability
This document aims at defining the cable harness routing in order to achieve the vehicle reliability
targets.
CHASSIS
Materials used and corresponding quantities
The electrical system consists of the following cable harnesses and parts:
•
1 Vehicle cable harness
•
1 Headlamp cable harness
•
1 License plate frame cable harness
•
1 Positive battery cable
•
1 Battery - engine ground cable
•
1 Ignition switch
•
1 ABS speed sensor
•
1 Start-up relay
•
5 Relays
•
1 Protection relay
•
1 Horn
•
1 Fall sensor
•
1 Headlamp
•
1 Taillight
•
1 Instrument panel
•
1 Right rear view mirror with turn indicator
•
1 Left rear view mirror with turn indicator
•
1 Rear right turn indicator
•
1 Rear left turn indicator
•
1 Fuel pump unit
•
1 Stand switch
R
ELAY LAYOUT
Component name
Low beam light relay
High beam light relay
Start-up relay
Protection relay
Injection relay
Fan control relay
Recovery logic relay (urgent service)
Electrical system
Location on the vehicle
Windshield front part
Windshield front part
Rear undertail section
Under the saddle next to the battery, left side
Under the saddle next to the battery, right side
In the niche of the headstock, on the left
In the niche of the headstock, on the right
ELE SYS - 99
Advertisement
