Electrical system
•
2 Self-tapping screws
•
4 AMP Superseal connector mountings
•
1 Mounting for the Framatome connector
•
2 Small black clamps
•
1 Rubber clamp
•
1 Flanged M6x16 screw
•
1 Secondary air solenoid mounting
•
3 Secondary air pipe (there are various types of pipes)
•
4 Rubber manifolds
•
4 Clip-on clamps
Motorcycle division
The wiring timing is subdivided in three essential
sections, as indicated in the figure.
1. Front section
2. Central section
3. Rear section
Special checks for the correct connection and laying of cables
It is extremely important that any security-locks for the following connectors are properly connected and
correctly tightened to ensure proper engine, and therefore proper vehicle, operation.
CHASSIS
•
Instrument panel connector
•
Demand sensor connectors
•
Start-up relay connector
•
Front speed sensor connector
•
Rear speed sensor connector
•
Fall sensor connector
•
Safety relay connector
•
Protection relay connector
•
Injection relay connector
•
Taillight connector
•
Fuel pump connector
•
Exhaust valve actuator connector
•
Engine-vehicle interface connector
•
Flywheel connector
ELE SYS - 102
RSV4 Factory a-PRC