RSV4 Factory a-PRC
•
Fit the retainer in the bearing groove.
•
Tighten the bearing retainer screw.
CLUTCH-SIDE
•
Heat up the crankcase to 150°C (302°F).
•
Prepare the following tools:
Specific tooling
020363Y Crankshaft oil seal punch D 20 mm
020359Y 42 x 47 mm punch
020376Y Adapter handle
•
Position the new bearings with their
groove on the outside diameter facing
outward with respect to the crankcase.
In this way it will be possible to install
the bearing retainer in the groove.
•
Using the suitable tools, fit the bearing
in the crankcase until tool stops.
Engine
ENG - 369