Advertisement
RSV4 Factory a-PRC
connector PIN 49 and sensor connector PIN 3 is a few tenths of an Ohm; If it is above that
value, restore cable harness. Replace the sensor if it is correct.
Error for unexpected air intake in the rear cylinder manifold P0210
•
signal not valid.
Error cause
•
A small difference between the estimated pressure and the measured pressure has been
detected: the measured pressure is higher than the estimated one (for example, the pipe
between sensor and throttle body is squashed or there is a hole in the intake manifold).
Troubleshooting
•
Check the pneumatic system between the pressure sensor and the socket to read pressure
on the throttle body; check that the intake manifold is in good conditions and the pressure
reading hole is clean.
Error for unexpected air intake in the front cylinder manifold P0211
•
signal not valid.
Error cause
•
A small difference between the estimated pressure and the measured pressure has been
detected: the measured pressure is higher than the estimated one (for example, the pipe
between sensor and throttle body is squashed or there is a hole in the intake manifold).
Troubleshooting
•
Check the pneumatic system between the pressure sensor and the socket to read pressure
on the throttle body; check that the intake manifold is in good conditions and the pressure
reading hole is clean.
Estimation error for rear cylinder intake manifold pressure P0215
•
too high pressure/too low pressure.
Error cause
•
A substantial difference between the estimated pressure and the measured pressure has
been detected (for example, the pipe between sensor and throttle body is fully detached/
clogged or squashed).
Troubleshooting
•
Check the pneumatic system between the pressure sensor and the socket to read pressure
on the throttle body; check that the intake manifold is in good conditions and the pressure
reading hole is clean: there is an evident defect in the intake and pressure reading systems.
Estimation error for front cylinder intake manifold pressure P0216
•
too high pressure/too low pressure.
Error cause
Electrical system
ELE SYS - 179
Advertisement
