APRILIA RSV4 Factory a-PRC 2009 Service Station Manual page 413

RSV4 Factory a-PRC

Insert the rubber buffer (6).

Insert the spring guide support ring (5),

noting the internal milling allowing the

spring guide retainer ring to be instal-

led against the support ring.

Insert the spring guide retainer ring (4).

Insert the spring guide (3).

Insert the spring guide retainer ring (1)

Insert the spring guide support ring (2),

noting the internal milling allowing the

spring guide retainer ring to be instal-

led against the support ring.

Insert the pumping member pin unit.

Use the Öhlins tool to tighten the

pumping member pin fixing ring nut to

40 Nm (29.50 lbf ft).

Install the following components on the

wheel holder stanchion (1) in the order

given: dust gaiter (3), retainer ring (4)

and oil seal (5).