RSV4 Factory a-PRC
CARRY OUT THE TESTS FROM THE SENSOR CONNECTOR TO THE SENSOR. IF NOT OK, RE-
STORE THE CABLE HARNESS/REPLACE THE SENSOR. IF OK, PERFORM THE TEST FROM PIN
20 AND 35 OF THE MARELLI CONTROL UNIT ENGINE CONNECTOR.
DIAGNOSTICS INSTRUMENT: LOGIC ERRORS
Engine speed sensor P0336
•
signal not valid
Error cause
•
Probable bad contact in the electric circuit detected at PIN 20 - 35 of the ENGINE connector
Troubleshooting
•
Check the electric circuit is in good conditions and the flywheel teeth cleaning and correct
positioning of the sensor in its own housing: if it is not, replace it. If it is OK, replace the
sensor
Twistgrip position sensor
REMOVAL
•
Remove the left fairing.
•
Loosen the two throttle cable nuts.
•
Unscrew and remove the three plate
fixing screws.
•
Remove the throttle cables.
•
Unscrew and remove the nut and the
stud bolt.
•
Retrieve the washers.
Electrical system
ELE SYS - 169