APRILIA RSV4 Factory a-PRC 2009 Service Station Manual page 360

Engine
Bearing removal
BALANCING COUNTERSHAFT BEARING RE-
MOVAL
•
Remove the lower crankcase.
•
Remove the countershaft.
FLYWHEEL-SIDE
•
Unscrew and remove the bearing re-
tainer screw.
•
Remove the lock.
•
Heat up the crankcase to 150°C (302°
F)
•
Position the general tool to pull out
bearings.
•
Remove the bearing.
See also
Crankcase opening
CLUTCH-SIDE
•
Unscrew and remove the bearing re-
tainer screw.
•
Remove the lock.
•
Heat up the crankcase to 150°C (302°
F)
•
Position the general tool to pull out
bearings.
•
Remove the bearing.
ENG - 360
RSV4 Factory a-PRC