Electrical system
TABLE J3 - EXHAUST VALVE ACTUATOR
Positioning and calibration Actuator - valve
Bowden cable (45) fitting procedure
•
Turn the opening cable (43) set screw
until the cable tension is identical to the
closing cable (44).
•
Finally tighten the lock nut on the set
screw.
TABLE K1 - PINION CASING AREA
46. Gear sensor cable harness routing
47. Oxygen sensor connector on the vehicle cable
harness
48. Gear sensor
49. Oxygen sensor connector
50. Stand switch cable harness routing
51. Oxygen sensor cable harness routing
52. Clamp
53. Stand switch
54. Lambda probe
55. Mounting
TABLE K2
Pass the cable harnesses behind the cable
grommet that closes the two fuel breather
pipes.
56. Quick shift cable harness routing
57. Oxygen sensor cable harness routing
58. Gear sensor cable harness routing
58A. Stand switch cable harness routing
ELE SYS - 118
RSV4 Factory a-PRC