Advertisement
RSV4 Factory a-PRC
is not engaged, at approx. 6000 rpm, throttles open very little because the requested torque is too low
(around 5-7°)
Rear throttle Potentiometer 1 (degrees)
•
Example value with key ON: 8°
•
Example value with engine on: 1.5°
With key set to ON, the throttle is kept in position by the springs (around 5 -7°). After the engine starts
up at idle, the throttle is kept close to the mechanical minimum (above or equal to 0.5°). When the gear
is not engaged, at approx. 6000 rpm, throttles open very little because the requested torque is too low
(around 5-7°)
Front throttle Potentiometer 1 (voltage)
•
Example value with key ON: 873 mV
•
Example value with engine on: 561 mV
Rear throttle Potentiometer 1 (voltage)
•
Example value with key ON: 883 mV
•
Example value with engine on: 536 mV
Front throttle Potentiometer 2 (voltage)
•
Example value with key ON: 4123 mV
•
Example value with engine on: 4426 mV
Rear throttle Potentiometer 2 (voltage)
•
Example value with key ON: 4113 mV
•
Example value with engine on: 4455 mV
Front throttle Potentiometer 2 (degrees)
•
Example value with key ON: 8.0°
•
Example value with engine on: 1.5°
With key set to ON, the throttle is kept in position by the springs (around 5 -7°). After the engine starts
up at idle, the throttle is kept close to the mechanical minimum (above or equal to 0.5°). When the gear
is not engaged, at approx. 6000 rpm, throttles open very little because the requested torque is too low
(around 5-7°)
Rear throttle Potentiometer 2 (degrees)
•
Example value with key ON: 8.2°
•
Example value with engine on: 1.6°
With key set to ON, the throttle is kept in position by the springs (around 5 -7°). After the engine starts
up at idle, the throttle is kept close to the mechanical minimum (above or equal to 0.5°). When the gear
is not engaged, at approx. 6000 rpm, throttles open very little because the requested torque is too low
(around 5-7°)
Electrical system
ELE SYS - 203
Advertisement
