APRILIA RSV4 Factory a-PRC 2009 Service Station Manual page 304

Engine
•
Then insert the tool to push the bushing
into the seat until it stops.
NOTE
IN THE EVENT OF SHAFT OR OIL SEAL REPLACEMENT, REFER TO THE TABLE AND ALWAYS
VERIFY THE CORRECT SIZING.
Model
MY 2009/2010
MY 2009/2010
MY 2011 - "V4" marking From No. 1002 to No.
1038 + From No. 7999
MY 2011 - "V4-A" mark- From No. 1002 to No.
ing 1440 + From No. 8785
MY 2011 - "V4-A" mark- From No. 1441 onwards Seat Diam. 22 mm (0.87
ing
•
Position the starting transmission gear
on the crankcase.
•
Position the gasket and the two dowel
pins in the clutch cover.
•
Insert the clutch cover, making sure to
have correctly engaged the clutch con-
trol lever and the rack shaft.
•
Screw the sixteen perimetric fixing
screws with the washers.
•
Tighten the screws working in stages
and diagonally.
•
Add engine oil up to the correct level.
ENG - 304
CLUTCH COVER AND COMPONENTS
Engine No. Clutch cover
Up to No. 2694 Seat Diam. 20 mm (0.79
From No. 2695 Seat Diam. 20 mm (0.79
Seat Diam. 20 mm (0.79
to No. 8784
Seat Diam. 20 mm (0.79
to No. 8922
RSV4 Factory a-PRC
Shaft
Diam. 10 mm (0.39)
in)
Ø 12 mm (0.47 in)
in)
Ø 12 mm (0.47 in)
in)
Ø 12 mm (0.47 in)
in)
Ø 12 mm (0.47 in)
in)
Oil seal
Diam. 10x20 mm
(0.39x0.79 in)
Diam. 12x20 mm
(0.47x0.79 in)
Diam. 12x20 mm
(0.47x0.79 in)
Diam. 12x20 mm
(0.47x0.79 in)
Diam. 12x20 mm
(0.47x0.79 in)