Starter Inspection - Mazda Mazda6 Workshop Manual Supplement

STARTER INSPECTION

MZR-CD (RF Turbo)
On-vehicle Inspection
1. Verify that the battery is fully charged.
• Charge if necessary. (See
2. Crank the engine and verify that the starter rotates smoothly without any noise.
• If not as specified, inspect the following:
— Remove the starter, and inspect the magnetic switch and the starter.
— Inspect the related wiring harness and the engine switch.
No Load Test
1. Verify that the battery is fully charged.
• Charge if necessary. (See
2. Connect the starter, battery, voltmeter and
ammeter as shown.
3. Operate the starter and verify that it rotates
smoothly.
4. Measure the voltage and current while the starter
is operating.
• If not as specified, replace the starter.
Specification
Voltage (V)
Current (A)
End Of Sie
STARTING SYSTEM
G–6 BATTERY RECHARGING.)
G–6 BATTERY RECHARGING.)
11
Below 130
ENGINE
SWITCH
B
M
TERMINAL S
STARTER
A6E471418400203
AMMETER
A
G
V
A6E4714W101
G–11