Dtc P0606; Dtc P0610 - Mazda Mazda6 Workshop Manual Supplement

DTC P0606

DTC P0606 PCM malfunction
DETECTION
• PCM does not read DTC from output devices.
CONDITION
POSSIBLE
• PCM internal malfunction
CAUSE
Diagnostic procedure
STEP
1
End Of Sie

DTC P0610

DTC P0610 Control module vehicle options error
DETECTION
• PCM data configuration error
CONDITION
• Configuration procedure has not been completed
POSSIBLE
• PCM malfunction
CAUSE
Diagnostic procedure
STEP
1 PERFORM DTC CONFIRMATION PROCEDURE
• Perform "DTC Confirmation Procedure".
(See F2–85 DTC CONFIRMATION
PROCEDURE)
• Is same DTC present during KOEO or KOER
self-test?
2 VERIFY TROUBLESHOOTING OF DTC P0610
COMPLETED
• Make sure to reconnect all disconnected
connectors.
• Clear DTC from PCM memory using WDS or
equivalent.
• Perform KOEO/KOER self-test.
(See F2–86 KOEO/KOER SELF-TEST
PROCEDURE)
• Is same DTC present?
3 VERIFY AFTER REPAIR PROCEDURE
• Perform "After Repair Procedure".
(See F2–86 AFTER REPAIR
• Is there any DTC present?
End Of Sie
ON-BOARD DIAGNOSTIC
INSPECTION
–
INSPECTION
PROCEDURE)
Replace PCM.
–
(See F2–64 PCM REMOVAL/INSTALLATION)
Yes Perform "PCM Configuration Procedure", then go to next
step.
(See F2–68 PCM CONFIGURATION)
No Intermittent concern exists. Go to "Intermittent Concern
Troubleshooting".
(See F2–227 INTERMITTENT CONCERN
TROUBLESHOOTING)
Yes Replace PCM, go to next step.
(See F2–64 PCM REMOVAL/INSTALLATION)
No Go to next step.
Yes Go to applicable DTC inspection.
(See F2–87 DTC TABLE)
No Troubleshooting completed.
A6E407001082239
ACTION
A6E407001082240
ACTION
F2–155
F2