Cover And Lpg Filler Neck: Check Condition, Clean If Necessary And Check O-Rings - Skoda Octavia II 2004 Maintenance Manual

– Slacken the drain plug -arrow- of the evaporator.
– Check if oil or other impurities are in the evaporator.
Note
If there are impurities in the evaporator, remove them from the
evaporator and replace the paper filter on the evaporator
⇒ "3.17.10 Paper filter on the evaporator: Change", page 101
– Screw in the drain plug again.
– Screw the evaporator holder onto the body.
– Screw down the evaporator with the two screws.
Tightening torque: 10 Nm.
– Screw down the screwed connection of the gas line on the gas
inlet of the filter housing.
Tightening torque: 10 Nm.
– Fit the gas hose to the fuel filter onto the connection at the
evaporator and secure it with a clamp.
– Fit the plug onto the high-pressure valve -N372- .
– Install the battery and battery tray ⇒ Electrical System; Rep.
gr. 27 .
For vehicles up to 12/2010 (emission level EU-4)
– Install liquefied petroleum gas control unit ⇒ 1.6/72 kW; 75
kW engine; Rep. gr. 24 .
– Connect the plug for the liquefied petroleum gas control unit
-1- and secure it with the securing mechanism -2-.
Continued for all vehicles
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
– Install air filter ⇒ 1.6/72 kW; 75 kW engine; Rep. gr. 24 .
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
– Activate gas system
⇒ "3.17.8 Activate gas system", page 98
– Carry out a leak tightness test on the liquefied petroleum gas
system (LPG)
⇒ "3.17.3 Check LPG gas system for leaks", page 86
3.17.13 Cover and LPG filler neck: Check con‐
dition, clean if necessary and check O-
rings
– Check the condition of the filler neck -A- and the screw cap
-B- and clean as required.
Octavia II 2004 ➤ , Octavia II 2010 ➤
.
.
.
Maintenance - Edition 01.2018
105