Crank Assembly Page; Disassembling And Assembling Engine; Removing And Installing Ribbed V-Belt - Skoda Octavia 1996 Service Manual

OCTAVIA

Disassembling and assembling engine

Removing and installing ribbed V-belt

Special tools, testers and aids required
♦ Torque wrench
♦ Drift T10060
Notes:
♦ The illustration shows the belt drive of mod-
els not fitted with air conditioning
♦ Mark the direction of running of the ribbed
V-belt before removing it. If an already used
belt is fitted on again to run in the opposite
direction, it may be destroyed. When install-
ing the belt, ensure it is correctly located in
the belt pulleys.
♦ Removing and installing AC compressor
⇒ Heating, Air conditioning; Repair Group 87.
1 - Ribbed V-belt
♦ mark the direction of running before
removing it.
♦ inspect for wear
♦ do not kink
♦ routing of ribbed V-belt on models not
fitted with AC ⇒ Fig. 1
♦ routing of ribbed V-belt on models fit-
ted with AC ⇒ Fig. 2
♦ removing and installing ribbed V-belt
⇒ page 13-3
♦ engines equipped with AC compres-
sor have a double ribbed V-belt
Edition 10.02
S00.5105.54.20
Crank Assembly
2 - 25 Nm
3 - Tensioning device for ribbed V-belt
♦ swivel with open-end wrench for slack-
ening ribbed V-belt ⇒ page 13-3
4 - Vibration damper
♦ can be installed in one position
5 - 45 Nm
6 - Alternator
♦ push back threaded bushes for retain-
ing bolts slightly to more easily posi-
tion the alternator against the bracket
7 - AC compressor
♦ do not open refrigerant circuit
♦ push back threaded bushes for retain-
ing bolts slightly to more easily posi-
tion the AC compressor against the
bracket
8 - Distance sleeve
9 - Bracket
10 - 45 Nm
♦ tightening sequence ⇒ page 13-3
11 - Banjo bolt, 30 Nm
12 - Seal
♦ replace
13 - Pressure line
14 - Hydraulic pump for power steering
♦ push back threaded bushes for retain-
ing bolts slightly to more easily posi-
tion the hydraulic pump against the
bracket
♦ removing and installing:
⇒ Running Gear; Repair Group 48
15 - Belt pulley
♦ for hydraulic pump
16 - Securing bolt
♦ replace bolt of strength class 8.8: 25
Nm with bolt of strength class 10.9
⇒ Parts List
♦ bolt of strength class 10.9: 40 Nm
♦ it is not permitted to combine different
strength classes
13
------------ 13-1 ------------