Replacing The Irmc Microsd Card - Fujitsu PRIMERGY TX2550 M5 Upgrade And Maintenance Manual

System board and components
▶ To eject the iRMC microSD card, gently push it in and then let go (1).
▶ Pull the iRMC microSD card straight out of its slot (2).
CAUTION
(not valid for Europe, Middle East, India and Africa)
The iRMC microSD card contains customer information.
▶
After removing the iRMC microSD card, hand the card over to
the customer.
▶
If the customer requests disposal of the defective microSD card,
proceed as follows: Using a pair of side-cutting pliers, cut the
microSD card in half.
Concluding steps
▶ If applicable, install the riser module, see
page 87.
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
14.5.4

Replacing the iRMC microSD card

Upgrade and Repair Unit
(URU)
Tools: a pair of side-cutting pliers
Preliminary steps
▶
"Locating the defective server" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
490
68.
82.
83.
49.
Upgrade and Maintenance Manual
"Installing the riser module" on
Hardware: 5 minutes
47.
50.
51.
TX2550 M5